Industrial laundry equipment in how to deal with noise?

         Commercial laundry equipment noise is too large will not only seriously interfere with the surrounding residents' normal life and work, for industrial laundry equipment itself, is extremely unfavorable. It will increase the load of industrial laundry equipment internal operation pressure, severely weakened the service life of industrial laundry equipment. Industrial laundry equipment appear noise caused by the improper operation are operators. ENEJEAN small make up, therefore, come to the conclusion that some prevent noise produced by the matters needing attention.

1.  Smooth industrial laundry equipment must be installed in place
2.  Industrial laundry equipment motor bearing or the shaft and bearing severe wear or fracture
3.  Industrial laundry equipment drive belt too tight
4.  The roller deformation and friction between outer barrel
5.  The shaft sealing ring too loose or too tight
6.  Damping suspension system out of balance

         In addition, we also can according to the industrial laundry equipment sound to determine how to solve the problem.
         If, industrial laundry equipment in the washing operation timing thrum boom boom. It is likely to be out mutual friction between roller and outer barrel or is caused by machines placed the ground not level off. When we adjust industrial laundry equipment center of gravity, smooth place can solve a problem;If the roller rotation cluck industrial laundry equipment, it is probably because driving wheel screw loosening, at this time, we can now remove the driving wheel, and then in the shaft bottom padded properly the thickness of the gasket, to eliminate the gap. To eliminate impact or friction of the two;If the issue were sound industrial laundry equipment belt driving, it is likely to be caused by the slack of drive belt. At this time, we can adjust the tension wheel tensioning belt.